Question: How To Remove A Stripped Carburetor Jet On A Honda Pump Motor?

Can you drill out a carburetor jet?

By drilling out your stock main jet to larger sizes you will be able to narrow down what jet size your carburetor needs. You will need a numbered drill bit set. The brass main jets are easy to drill so you can get by with one of these inexpensive drill bit sets.

How do you free up a stuck carburetor?

Tap the top of the carburetor gently but firmly with a small hammer or screwdriver handle. Tap the bowl of the carburetor firmly. This may loosen a stuck float valve, allowing the float to work properly until you can fix the problem permanently.

Can you drill out pilot jets?

I would strongly recommend you NOT drill out the holes in your pilot jet. Just spend the two dollars and buy the new one. and here I thought I was the only one who thought about drilling out my jets. The only difference between me and you is that I actually went through with it.

How do I know my main jet size?

Consult your manual first to find the stock size. Also pay attention to the numbers on the side of your old jets, which you’ll be able to see in the steps to come. A larger jet number means a bigger hole and more fuel. A smaller jet number has smaller holes and should be used if your engine needs to run more lean.

You might be interested:  How Many Ccs Carburetor Is On Vintage Craftsman 2.75 14" Gas Chainsaw?

How do you clean a carburetor without taking it apart?

Here’s the process:

  1. Safety checks.
  2. Move the bike to a clean, clear bit of floor.
  3. Drape a plain-coloured cloth over the casings below the carb.
  4. Drain the float bowls.
  5. Remove the float bowl, often held on by four crosshead screws.
  6. Remove the float – it’s held in place by a small pin that can just be pushed out.

How do you remove a broken fuel mixture screw?

The “Push Pin Trick” and “Pick Trick” techniques make this possible. This method uses a push pin and box wrench to push out the broken tip of the idle mixture screw. The “Push Pin Trick” method. This method uses a mechanic’s pick and wire spark plug guage to push out and clear the broken tip of the idle mixture screw.

How do you remove a needle from a slide?

On the top of the slide, there is a clip holding the needle down. It takes a 2.5mm Allen wrench. Just need to loosen the bolt a bit, then the clip slides out of the way, and you pull the needle out through the top. That would be the proper way to remove the needle, not the needle jet.

Leave a Reply

Your email address will not be published. Required fields are marked *