Husqvarna 128 Ld Which Carburetor Line Is The Filter Attached To?

What fuel line goes to the carburetor?

The (clear) main fuel line with the filter (filter inside the fuel tank) goes to the bottom of the carburetor (or the elbow shaped nipple). The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb.

Where is the fuel filter on a trimmer?

The fuel filter is right inside the gas tank. It’s usually oblong, about an inch or two in length, and covered with a fine screen or fabric, and it’s pushed onto the end of the fuel line, which allows gas to flow from the tank to the carburetor.

Why do Weedeaters have 2 fuel lines?

The supply lines need to connect to the fuel tank so that, when the weed eater is held in the operating position, they are below the fuel level. The vent and return lines will typically attach higher up. The lower line on the carburetor should be the supply line, the upper one would be above fuel to vent air.

What size is Husqvarna fuel line?

Fuel line size: 3/8 in. x 2-1/2 in.

What is the gas to oil ratio for a Husqvarna chainsaw?

The correct mixing ratio for your Husqvarna is detailed in your product’s owner’s manual. But as a general guide, a fuel-to-oil ratio of 50:1 is recommended for Husqvarna products up to and including 75cc. That comes out to 2.5 fluid ounces of oil per 1 gallon of gas.

You might be interested:  Quick Answer: How To Adjust The Floot 69 Mustang Two Barrel Carburetor?

How do you clean a chainsaw fuel filter?

Brush the air filter gently with a soft brush or wash it in warm soapy water then dry it. Do not use compressed air to clean it – compressed air can blow holes in the filter, allowing dust and debris into your carburetor.

Leave a Reply

Your email address will not be published. Required fields are marked *